The MW A-Arm jig simplifies installing an a-arm front end on a dragster or funny car chassis.

Adjuster wrench for cases with the 3.062 and 3.25 bores.

Adjuster wrench for 3.812 cases.

10" aluminum square base plate. 7" wide shoulder.

Round 4340 steel plate that locks in base bore of bearing press plate to prevent spreading

Differential assembly fixture

This is a recommended tool for checking the pressure setting on racing disc brakes at the wheel.

The T&D pinion depth checker allows you to precisely set pinion depth on most popular rears

Adapter to use p/n 400D alignment bar on MW 12” Rear.

Allows for perfect alignment between rear end and engine

Allows for perfect alignment between rear end and engine

Socket used to remove MW dust caps from the front brake hub. (ea)