Toll Free: 1-866-508-6394
OR Contact Us
OR Contact Us
Shop by Category
MW offers several steel 9" Ford housings. Housings with 3" diameter tubes are built with brand new coil spring centers, 4130 tubes with internal bracing, and MW housing ends. MW also offers bolt-in housings for some popular applications that are built from stock tube housings with all required suspension mounts. All housings have a lube fill cap, drain, housing vent, and thirdmember studs installed. We can install custom brackets to any of these housings for an additional charge. If you are going to install your mount brackets in the car, we can build the housing with the ends tacked on, so it can be returned for final housing end installation. This will eliminate the welding distortion caused by the bracket installation process.
Assembly includes housing, thirdmember, axles, wheel bearings, and wheel studs (less brakes)
Assembly includes housing, thirdmember, axles, wheel bearings, wheel studs (less brakes)
Includes housing, thirdmember, axles, and brakes, bearings, and drive stud kit
Includes housing, axles, and brakes (less thirdmember)
Aluminum through bolt case, 40 spline axles, lightweight steel spool, 35 spline 9" pro gear, steel 4-Link brackets, with tie bar, MW disc brakes, drive studs, 1350 series U-joint
With steel end bells and 4130 tubes, choice of housing ends, lightweight aluminum thirdmember with 31 spline posi and 1350 series pinion yoke, MW pro street axles, Timken® wheel bearings, and studs. Minimum of 34" housing width (No brakes). Street or Strip applications.
Aluminum housing with pro street axles, lightweight aluminum thirdmember with 31 spline posi and 1350 series pinion yoke, aluminum end bells and 4130 tubes, and choice of housing ends. minmum of 38" housing width (less brakes)